Difficulty

Moderate

Steps

16

Time Required

                          10 minutes

Sections

7

  • Rear Case
  • 2 steps
  • Midframe
  • 2 steps
  • Rear Facing Camera
  • 3 steps
  • Front Facing Camera
  • 1 step
  • Headphone Jack
  • 2 steps
  • Motherboard
  • 5 steps
  • Dual SIM Slot
  • 1 step

Flags

0

  • BackSony Xperia T2 Ultra Dual

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Case
  • Using the spudger, pry open the back cover by starting alongside the edge of the back cover.

Using the spudger, pry open the back cover by starting alongside the edge of the back cover.

1024

Step 2

  • Once the part of the back cover has been opened up. Slide the spudger to pry completely detach the cover from the phone.

Once the part of the back cover has been opened up. Slide the spudger to pry completely detach the cover from the phone.

Step 3

              Removing the internal cover
  • Using the Phillips #00 Precision screwdriver, take out 8 silver screws (3.15mm) and 5 gold screws (3.9mm) for a total of all the screws attached to the flat plate. 3 of the gold screws are located at the top of the phone and the other 2 screws are located at the bottom of the phone.

Using the Phillips #00 Precision screwdriver, take out 8 silver screws (3.15mm) and 5 gold screws (3.9mm) for a total of all the screws attached to the flat plate. 3 of the gold screws are located at the top of the phone and the other 2 screws are located at the bottom of the phone.

Step 4

  • To remove the internal cover, use the plastic spudger tool and pry the cover from the phone as shown in the picture.

To remove the internal cover, use the plastic spudger tool and pry the cover from the phone as shown in the picture.

Step 5

              Removing Chip
  • To take out the back facing camera, flip open the flap labelled ‘film’ to reveal the chip that connects to the motherboard.

To take out the back facing camera, flip open the flap labelled ‘film’ to reveal the chip that connects to the motherboard.

Step 6

  • Use the tweezer, carefully pry open the chip for the back facing camera.

Use the tweezer, carefully pry open the chip for the back facing camera.

Step 7

              Remove back facing camera
  • Then using the tweezer, carefully remove the back facing camera component.

Then using the tweezer, carefully remove the back facing camera component.

Step 8

              Removing the Front Camera
  • Using the tweezer, carefully pry open the chip for the front facing camera as shown. Then using the tweezer, carefully remove the front facing camera component.

Using the tweezer, carefully pry open the chip for the front facing camera as shown. Then using the tweezer, carefully remove the front facing camera component.

Step 9

              Removing chip
  • Using tweezer, locate the audio jack as shown and pull out the chip connected to the motherboard.

Using tweezer, locate the audio jack as shown and pull out the chip connected to the motherboard.

Step 10

              Remove audio jack
  • Carefully remove the audio jack by using the tweezers and pull firmly straight out of the motherboard.

Carefully remove the audio jack by using the tweezers and pull firmly straight out of the motherboard.

Step 11

              Motherboard
  • Using tweezers, locate the battery connector and carefully pull up to disconnect it.

Using tweezers, locate the battery connector and carefully pull up to disconnect it.

Step 12

  • Carefully remove the button circuit connector by using tweezers and gently pulling up.

Carefully remove the button circuit connector by using tweezers and gently pulling up.

Step 13

  • Carefully remove the silver plug by using the tweezers to lift straight up.

Carefully remove the silver plug by using the tweezers to lift straight up.

Step 14

  • Carefully remove the SIM card connector using tweezers by gently pulling it straight up.

Carefully remove the SIM card connector using tweezers by gently pulling it straight up.

Step 15

  • Using tweezers, carefully remove the motherboard by pulling it up and out of the backing.

Using tweezers, carefully remove the motherboard by pulling it up and out of the backing.

Step 16

              Dual SIM Slot
  • Using the Tweezers, carefully pry the the dual SIM slot off the sticky substance used to hold it down.

Using the Tweezers, carefully pry the the dual SIM slot off the sticky substance used to hold it down.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Austin Kreutzjans

Member since: 03/01/2017

157 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       IUPUI, Team S1-G3, Harley Spring 2017                        

                                                  Member of IUPUI, Team S1-G3, Harley Spring 2017 



                    IUPUI-HARLEY-S17S1G3                     


                                            4 Members                     


                                            3 Guides authored

profeduards - Sep 2, 2017

Reply

Clear video and tutorial!

But why make the process too long where in fact you can do it fast and simple by directly pulling out the dual sim card reader/slot off the board right after removing the mid-frame cover (after Step 4), and thereafter put in the replacement part?

The 16 steps can be done in just 5 or 6 steps.

Might as well re-title this to: Partial Disassembly of Xperia T2 Ulta Dual.