Difficulty
Moderate
Steps
10
Time Required
15 - 20 minutes
Sections
1
- Touch screen Glass, LCD Display, Loudspeaker, Earpiece
- 10 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackSony Xperia E1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
___________________________ Video tutorial: ___________________________
What you need
Video Overview
Step 1
Touch screen Glass, LCD Display, Loudspeaker, Earpiece
- Turn off the phone, remove the battery, SIM card and micro SD card.
- The screws are Torx T4. One of them, near the microSD card reader is different.
Turn off the phone, remove the battery, SIM card and micro SD card.
The screws are Torx T4. One of them, near the microSD card reader is different.
1024
Step 2
- Use a plastic tool to remove the middle frame.
- Loudspeaker
Use a plastic tool to remove the middle frame.
Loudspeaker
Step 3
- Touch screen flex cable. Disconnect it.
- LCD Display flex cable. Open the connector.
- The logic board is held to the display frame by several plastic locking clips. Use a plastic tool to remove it.
Touch screen flex cable. Disconnect it.
LCD Display flex cable. Open the connector.
The logic board is held to the display frame by several plastic locking clips. Use a plastic tool to remove it.
Step 4
- Earpiece.
Earpiece.
Step 5
- Release the LCD display from the main board.
Release the LCD display from the main board.
Step 6
- If the glass is broken, put some scotch tape to prevent it from breaking to pieces.
- Use a hot air to soften the adhesive tape.
- You can use a hairdryer.
- Start with separating at the middle, where the contact area is smaller.
If the glass is broken, put some scotch tape to prevent it from breaking to pieces.
Use a hot air to soften the adhesive tape.
You can use a hairdryer.
Start with separating at the middle, where the contact area is smaller.
Step 7
- Use a plastic tool for separating the glass from the frame.
Use a plastic tool for separating the glass from the frame.
Step 8
- Clean the frame.
- Put adhesive tape if the new spare part doesn’t have any.
- Be careful, don’t cover the holes for the microphone, proximity sensor, etc.
- Install the new Digitizer.
Clean the frame.
Put adhesive tape if the new spare part doesn’t have any.
Be careful, don’t cover the holes for the microphone, proximity sensor, etc.
Install the new Digitizer.
Step 9
- Use again hot air and some pressure to stick the glass better.
- Start wit reassembling.
Use again hot air and some pressure to stick the glass better.
Start wit reassembling.
Step 10
- That’s all.
- .
- .
- .
- .
- .
- .
- Did you do it successfully?
That’s all.
.
Did you do it successfully?
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 1 other contributor
ZFix
Member since: 12/09/2013
187,195 Reputation
330 Guides authored
Badges:
35
+32 more badges
Team
Master Techs
Member of Master Techs
Community
310 Members
1,168 Guides authored
rhaman516 - Mar 5, 2016
Reply
Sony xperia d2005 touch
Om Prakash - Oct 29, 2016
Reply
Hi I have a problem with wifi it’s a hardware issue as I dropped it yesterday since from then the issue started please help me to fix it
