Difficulty
Moderate
Steps
5
Time Required
20 minutes
Sections
1
- USB Cable
- 5 steps
Flags
0
BackSony XAV-AX100
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
USB Cable
- Place the device on a flat surface, upside down, so the bottom of the screen would be facing upwards.
- Remove the ten 3.5mm Phillips #0 screws from the back plate.
Place the device on a flat surface, upside down, so the bottom of the screen would be facing upwards.
Remove the ten 3.5mm Phillips #0 screws from the back plate.
1024
Step 2
- Use a plastic opening tool to remove the back plate.
- Don’t remove completely as there will still be cables connected.
Use a plastic opening tool to remove the back plate.
Don’t remove completely as there will still be cables connected.
Step 3
- Disconnect the USB cable from the display board.
Disconnect the USB cable from the display board.
Step 4
- Adjust the rubber holders that are keeping the USB cable still on the motherboard, so you can remove the cable entirely from the inner compartment.
- The rubber holders are extremely sensitive to any applied force. Therefore, be careful while turning them around.
Adjust the rubber holders that are keeping the USB cable still on the motherboard, so you can remove the cable entirely from the inner compartment.
The rubber holders are extremely sensitive to any applied force. Therefore, be careful while turning them around.
Step 5
- Remove the 3.5mm Phillip #0 screw that secures the USB cable to the back panel.
- Pull the USB cable off of the back plate.
Remove the 3.5mm Phillip #0 screw that secures the USB cable to the back panel.
Pull the USB cable off of the back plate.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Abdulaziz Redha
Member since: 02/22/2018
741 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
USF Tampa, Team S1-G5, Cagle Spring 2018
Member of USF Tampa, Team S1-G5, Cagle Spring 2018
USFT-CAGLE-S18S1G5
2 Members
5 Guides authored
mudylla - Jul 13, 2020
Reply
Where i can get replacement lead?
Andy 777 - Jan 10, 2021
Reply
where can i get a replacement lead for this please
im in the UK