Sony Vaio Tap 11 Power Jack Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          30 minutes            

Sections

3

• Screen Assembly
• 3 steps
• Battery
• 2 steps
• Power Jack
• 4 steps

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

• BackSony Vaio Tap 11

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Screen Assembly               

• Begin by opening the HDMI/USB port cover on the left edge.
• Remove the three #000 headed, 3 mm long screws located underneath the port cover.

Begin by opening the HDMI/USB port cover on the left edge.

Remove the three #000 headed, 3 mm long screws located underneath the port cover.

1024

Step 2

• Locate and open the Micro SD slot on the top side of the device.
• Remove the two screws located beneath the cover.

Locate and open the Micro SD slot on the top side of the device.

Remove the two screws located beneath the cover.

Step 3

• Attach the suction cup to the top right area of the screen.
• Pull to separate the screen from the rest of the device.
• Be aware of the front camera cable that is still connected to the rest of the device.
• Detach the display ribbon cable.

Attach the suction cup to the top right area of the screen.

Pull to separate the screen from the rest of the device.

Be aware of the front camera cable that is still connected to the rest of the device.

Detach the display ribbon cable.

Step 4

              Battery               

• Disconnect the battery from the motherboard by pulling out the cable below the fan.

Disconnect the battery from the motherboard by pulling out the cable below the fan.

Step 5

• Remove the seven 3 mm Phillips #000 screws that hold the battery in place.
• Carefully remove the battery from the back assembly.

Remove the seven 3 mm Phillips #000 screws that hold the battery in place.

Carefully remove the battery from the back assembly.

Step 6

              Power Jack               

• Remove the two 3mm Phillips #000 screws from the bottom left corner of the device.

Remove the two 3mm Phillips #000 screws from the bottom left corner of the device.

Step 7

• Unplug the jack from the motherboard.

Unplug the jack from the motherboard.

Step 8

• Remove the metal covering.

Remove the metal covering.

Step 9

• Pull out the cable and jack assembly.

Pull out the cable and jack assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Alexander Bridges                     

Member since: 09/16/2015

1,217 Reputation

                                      7 Guides authored                  



                       Badges:
                       17







                                                        +14 more badges                           

Team

                       IUPUI, Team 1-2, Harley Fall 2015                        

                                                  Member of IUPUI, Team 1-2, Harley Fall 2015 



                    IUPUI-HARLEY-F15S1G2                     


                                            4 Members                     


                                            20 Guides authored                     

James Toal - Apr 28, 2017

Reply

I wonder if you have the part number or can supply this power jack?

mikebeard65 - Aug 4, 2017

Reply

Yes, Where can I find this replacement part?