Difficulty
Easy
Steps
6
Time Required
15 - 25 minutes
Sections
2
- Battery
- 1 step
- Hard Drive
- 5 steps
Flags
0
BackSony Vaio SVT131A11L
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
It’s also important to note that in addition to the high-capacity hard drive that we cover in this guide, there is a small NVMe solid state drive which is commonly used as a boot-device for this series of laptop. If you complete this replacement and your computer is still exhibiting the same issues, check the status of the SSD as well.
What you need
Step 1
Battery
- Carefully grab the edges of the laptop and flip it over to reveal the back panel.
- The battery is located on the lower half of the back panel, and contains three 10mm flat-head screws.
- Unscrew the three 10mm flat-head screws using a flat-head screw driver.
- Lift the battery from the lip closest to the middle screw to remove the battery entirely.
Carefully grab the edges of the laptop and flip it over to reveal the back panel.
The battery is located on the lower half of the back panel, and contains three 10mm flat-head screws.
Unscrew the three 10mm flat-head screws using a flat-head screw driver.
Lift the battery from the lip closest to the middle screw to remove the battery entirely.
1024
Step 2
Hard Drive
- The Hard Drive bay cover has three Phillips head screws at two different lengths. Be sure to organize your screws, as improper replacement will result in damage to your device.
- The middle Phillips head screw is 10mm in length and will only fit in this thread. Unscrew the 10mm Phillips head screw and keep it separate from the other two screws in this step.
- Unscrew the two remaining 5mm Phillips head screws on the left and right side of the hard drive bay cover.
- Lift the panel to remove it.
The Hard Drive bay cover has three Phillips head screws at two different lengths. Be sure to organize your screws, as improper replacement will result in damage to your device.
The middle Phillips head screw is 10mm in length and will only fit in this thread. Unscrew the 10mm Phillips head screw and keep it separate from the other two screws in this step.
Unscrew the two remaining 5mm Phillips head screws on the left and right side of the hard drive bay cover.
Lift the panel to remove it.
Step 3
- Remove the three 5mm Phillips head screws that secure the Hard Drive bay to the back panel.
Remove the three 5mm Phillips head screws that secure the Hard Drive bay to the back panel.
Step 4
- Remove the Hard Drive bay by gently pulling the black plastic tab away from the SATA connector.
- When removing the hard drive bay, it is important not to pull the black tab too hard, it may rip off/cause damage to the SATA connector, resulting in much bigger issues.
- Using a plastic pry-tool to push the drive away from the SATA connector can also help at this step.
Remove the Hard Drive bay by gently pulling the black plastic tab away from the SATA connector.
When removing the hard drive bay, it is important not to pull the black tab too hard, it may rip off/cause damage to the SATA connector, resulting in much bigger issues.
Using a plastic pry-tool to push the drive away from the SATA connector can also help at this step.
Step 5
- Remove the two 5mm Phillips head screws on either side of the Hard Drive bay. There are four screws total in this step.
Remove the two 5mm Phillips head screws on either side of the Hard Drive bay. There are four screws total in this step.
Step 6
- Remove your damaged hard drive and insert the new hard drive into the enclosure.
- Use the same four 5mm Phillips head screws to attach the drive to the enclosure.
Remove your damaged hard drive and insert the new hard drive into the enclosure.
Use the same four 5mm Phillips head screws to attach the drive to the enclosure.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 4 other contributors
Benjamin
Member since: 10/18/2017
651 Reputation
4 Guides authored
Badges:
15
+12 more badges
Team
UMass Dartmouth, Team S4-G5, Julie Fall 2017
Member of UMass Dartmouth, Team S4-G5, Julie Fall 2017
UMASSD-JULIE-F17S4G5
3 Members
5 Guides authored
Stephen Exley - Sep 19, 2018
Reply
I would like to know if you sell the adapter for the hard drive because I have this laptop and all I need is the hard drive adapter to connect a hard drive if you could email me at stephenwrayexley@gmail.com I would greatly appreciate that