Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
2
- Battery
- 4 steps
- Speaker Panel
- 2 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackSony VAIO PCG-F360
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Battery
- Position the laptop screen-side down as shown.
- In this position the battery housing will be located on the right hand side.
Position the laptop screen-side down as shown.
In this position the battery housing will be located on the right hand side.
1024
Step 2
- Lift the panel up and then out to gain access to the battery.
Lift the panel up and then out to gain access to the battery.
Step 3
- Use the indentations to pull the old battery out.
Use the indentations to pull the old battery out.
Step 4
- The battery is now removed and it is safe to move on to uninstalling other components.
The battery is now removed and it is safe to move on to uninstalling other components.
Step 5
Speaker Panel
- There are two screws on the left hand side of the laptop near the IR receiver. remove them using a #00 Philips head screwdriver.
- Slide the speaker panel towards the left, then carefully flip it over onto the keyboard.
- Make sure not to pull the speaker panel away from the computer just yet - it is still connected!
There are two screws on the left hand side of the laptop near the IR receiver. remove them using a #00 Philips head screwdriver.
Slide the speaker panel towards the left, then carefully flip it over onto the keyboard.
Make sure not to pull the speaker panel away from the computer just yet - it is still connected!
Step 6
- Push the beige tab in the direction of the ribbon. it should only move a small amount
- Remove the ribbon by gently pulling on it, there should be little or no resistance.
- Now the speaker panel can be set aside.
Push the beige tab in the direction of the ribbon. it should only move a small amount
Remove the ribbon by gently pulling on it, there should be little or no resistance.
Now the speaker panel can be set aside.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Hannah Millea
Member since: 03/11/2014
401 Reputation
4 Guides authored
Badges:
4
+1 more badge
Team
UMass Dartmouth, Team 3-5, Calaway Spring 2014
Member of UMass Dartmouth, Team 3-5, Calaway Spring 2014
UMASSD-CALAWAY-S14S3G5
2 Members
4 Guides authored