Difficulty

Moderate

Steps

7

Time Required

                          15 minutes

Sections

2

  • Battery
  • 2 steps
  • Keyboard
  • 5 steps

Flags

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSony VAIO PCG-933A

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn the laptop upside down so that the top is sitting on a flat surface.
  • If you are looking at the bottom of the laptop the battery is located on the front right side of the laptop; the opposite side from the floppy disk drive.

Turn the laptop upside down so that the top is sitting on a flat surface.

If you are looking at the bottom of the laptop the battery is located on the front right side of the laptop; the opposite side from the floppy disk drive.

1024

Step 2

  • As shown by the arrow, slide the plastic cover up and then pull out and downwards.
  • You should now be able to pull the battery out.

As shown by the arrow, slide the plastic cover up and then pull out and downwards.

You should now be able to pull the battery out.

Step 3

              Keyboard
  • Remove the four 16 mm screws bordering the edge of the laptop using a Phillips #0 screwdriver.

Remove the four 16 mm screws bordering the edge of the laptop using a Phillips #0 screwdriver.

Step 4

  • Remove the 4mm screw on the right rear side of the laptop next to the audio ports using a Phillips #0 screwdriver.
  • This will release the speaker grille.

Remove the 4mm screw on the right rear side of the laptop next to the audio ports using a Phillips #0 screwdriver.

This will release the speaker grille.

Step 5

  • Flip the computer so the key board is facing up.

Flip the computer so the key board is facing up.

Step 6

  • Slide the blue speaker grille (located above the keyboard) to the right and gently pull upward. The grille will still be connected by a white electrical strip.
  • Carefully pull out the white electrical strip. By doing this you will remove the speaker grille.

Slide the blue speaker grille (located above the keyboard) to the right and gently pull upward. The grille will still be connected by a white electrical strip.

Carefully pull out the white electrical strip. By doing this you will remove the speaker grille.

Step 7

  • Remove the 4mm screw in the center using a Phillips screwdriver.
  • Carefully and slowly pull the green strip straight up (away from the laptop) to disconnect it. Make sure not to pull too hard to avoid breaking.
  • The keyboard can now be removed.

Remove the 4mm screw in the center using a Phillips screwdriver.

Carefully and slowly pull the green strip straight up (away from the laptop) to disconnect it. Make sure not to pull too hard to avoid breaking.

The keyboard can now be removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 


                    Sara Lillard

Member since: 04/11/2011

165 Reputation

                                      8 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 12-36, Maness Spring 2011                        

                                                  Member of Cal Poly, Team 12-36, Maness Spring 2011 



                    CPSU-MANESS-S11S12G36                     


                                            4 Members                     


                                            16 Guides authored