Difficulty

Moderate

Steps

8

Time Required

                          10 - 15 minutes

Sections

2

  • Battery
  • 4 steps
  • Speaker
  • 4 steps

Flags

0

  • BackSony Vaio Fit SVF15N26CXB

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the following ten screws from the bottom case of the laptop:
  • Two 6.5mm Phillips #00 Phillips screws.
  • Four 8.95mm Phillips #00 screws.
  • Four 6.25mm Phillips #00 screws.
  • The screws may be hidden underneath a rubber foot that can be removed with a spudger.

Remove the following ten screws from the bottom case of the laptop:

Two 6.5mm Phillips #00 Phillips screws.

Four 8.95mm Phillips #00 screws.

Four 6.25mm Phillips #00 screws.

The screws may be hidden underneath a rubber foot that can be removed with a spudger.

1024

Step 2

  • Use a plastic opening tool to separate the bottom cover from the laptop.
  • Lift the lower cover and pull away from the laptop.

Use a plastic opening tool to separate the bottom cover from the laptop.

Lift the lower cover and pull away from the laptop.

Step 3

  • Remove the eight Phillips #00 screws from the battery:
  • Six 4.65mm screws.
  • Two 4.65mm screws.

Remove the eight Phillips #00 screws from the battery:

Six 4.65mm screws.

Two 4.65mm screws.

Step 4

  • Lift the battery up and pull it out of the laptop.

Lift the battery up and pull it out of the laptop.

Step 5

              Speaker
  • Remove six 5.75mm Phillips #00 screws from the speakers.

Remove six 5.75mm Phillips #00 screws from the speakers.

Step 6

  • Use a spudger to flip up the black latch on the four ZIF connectors.
  • Remove the four ribbon cables from the ZIF connectors.
  • Disconnect the speaker from the board.

Use a spudger to flip up the black latch on the four ZIF connectors.

Remove the four ribbon cables from the ZIF connectors.

Disconnect the speaker from the board.

Step 7

  • Using tweezers, carefully unwind the speakers’ wires from the plastic brackets holding them.
  • Where the wire is stuck under tape, gently pull the tape up until the wire is free.
  • Do not remove the tape.

Using tweezers, carefully unwind the speakers’ wires from the plastic brackets holding them.

Where the wire is stuck under tape, gently pull the tape up until the wire is free.

Do not remove the tape.

Step 8

  • Remove the speakers by picking the left and right pieces up and lifting them up and out of the computer.

Remove the speakers by picking the left and right pieces up and lifting them up and out of the computer.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Althea McDavid

Member since: 02/14/2018

842 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team S2-G4, Nance Spring 2018                        

                                                  Member of USF Tampa, Team S2-G4, Nance Spring 2018 



                    USFT-NANCE-S18S2G4                     


                                            4 Members                     


                                            11 Guides authored