Difficulty
Easy
Steps
7
Time Required
5 - 10 minutes
Sections
2
- Battery
- 4 steps
- Hard Drive
- 3 steps
Flags
0
BackSony Vaio Fit SVF15N26CXB
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the following ten screws from the bottom case of the laptop:
- Two 6.5mm Phillips #00 Phillips screws.
- Four 8.95mm Phillips #00 screws.
- Four 6.25mm Phillips #00 screws.
- The screws may be hidden underneath a rubber foot that can be removed with a spudger.
Remove the following ten screws from the bottom case of the laptop:
Two 6.5mm Phillips #00 Phillips screws.
Four 8.95mm Phillips #00 screws.
Four 6.25mm Phillips #00 screws.
The screws may be hidden underneath a rubber foot that can be removed with a spudger.
1024
Step 2
- Use a plastic opening tool to separate the bottom cover from the laptop.
- Lift the lower cover and pull away from the laptop.
Use a plastic opening tool to separate the bottom cover from the laptop.
Lift the lower cover and pull away from the laptop.
Step 3
- Remove the eight Phillips #00 screws from the battery:
- Six 4.65mm screws.
- Two 4.65mm screws.
Remove the eight Phillips #00 screws from the battery:
Six 4.65mm screws.
Two 4.65mm screws.
Step 4
- Lift the battery up and pull it out of the laptop.
Lift the battery up and pull it out of the laptop.
Step 5
Hard Drive
- Remove the four 3.20mm Phillips #00 screws from the hard drive.
Remove the four 3.20mm Phillips #00 screws from the hard drive.
Step 6
- Use a spudger to flip up the black latch on the ZIF connectors.
- Pull the ribbon cables out of the ZIF connectors and fold them over the hard drive.
- Disconnect the hard drive and remove.
Use a spudger to flip up the black latch on the ZIF connectors.
Pull the ribbon cables out of the ZIF connectors and fold them over the hard drive.
Disconnect the hard drive and remove.
Step 7
- Remove the four 3.70mm Phillips #00 screws from the hard drive mounting case.
- Carefully peel foil tray off of hard drive.
Remove the four 3.70mm Phillips #00 screws from the hard drive mounting case.
Carefully peel foil tray off of hard drive.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Althea McDavid
Member since: 02/14/2018
842 Reputation
6 Guides authored
Badges:
10
+7 more badges
Team
USF Tampa, Team S2-G4, Nance Spring 2018
Member of USF Tampa, Team S2-G4, Nance Spring 2018
USFT-NANCE-S18S2G4
4 Members
11 Guides authored