Difficulty

Easy

Steps

6

Time Required

                          15 minutes            

Sections

1

  • Rear Camera
  • 6 steps

Flags

0

  • BackSony Tablet S

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Rear Camera               
  • Ensure that the device is completely turned off before attempting a repair. The battery may still have charge; use caution touching the components.
  • Use a plastic opening tool to remove the two rubber grips on the back of the tablet.

Ensure that the device is completely turned off before attempting a repair. The battery may still have charge; use caution touching the components.

Use a plastic opening tool to remove the two rubber grips on the back of the tablet.

1024

Step 2

  • Remove the two 10mm Phillips #0 screws located under the grips.

Remove the two 10mm Phillips #0 screws located under the grips.

Step 3

  • Flip the tablet over and use a plastic opening tool to pry the casing away from the top of the screen. Push the back cover off.
  • There is adhesive holding the case on located at the top of the screen. Push the casing toward the top of the screen while also wiggling it back and forth.

Flip the tablet over and use a plastic opening tool to pry the casing away from the top of the screen. Push the back cover off.

There is adhesive holding the case on located at the top of the screen. Push the casing toward the top of the screen while also wiggling it back and forth.

Step 4

  • Remove the copper ribbon cable by gently using a spudger to pry it up from its socket.
  • Use caution when removing the cable, as the socket is very fragile.

Remove the copper ribbon cable by gently using a spudger to pry it up from its socket.

Use caution when removing the cable, as the socket is very fragile.

Step 5

  • Use a finger or a spudger to pull on camera housing.

Use a finger or a spudger to pull on camera housing.

Step 6

  • Remove the assembly from the plastic shielding.

Remove the assembly from the plastic shielding.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Austin Mann                     

Member since: 09/28/2016

287 Reputation

                                      5 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       USF Tampa, Team 3-5, Passmore Fall 2016                        

                                                  Member of USF Tampa, Team 3-5, Passmore Fall 2016 



                    USFT-PASSMORE-F16S3G5                     


                                            3 Members                     


                                            5 Guides authored