Sony Srs X5 Bluetooth Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          8 minutes

Sections

Battery
3 steps
Speaker
4 steps
Bluetooth
3 steps

Flags

BackSony SRS-X5
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

To gain access to the 6 bottom screws remove the following. Remove the adhered 4 corner foam pads on the bottom of the speaker using the blue plastic opening tool to reveal the screws underneath. Remove the adhered 2 center plastic squares.
Make sure the speaker is unplugged and powered down before doing any work on the device.

To gain access to the 6 bottom screws remove the following. Remove the adhered 4 corner foam pads on the bottom of the speaker using the blue plastic opening tool to reveal the screws underneath. Remove the adhered 2 center plastic squares.

Make sure the speaker is unplugged and powered down before doing any work on the device.

1024

Step 2

Unscrew the six 6mm screws with a Phillips head #1 screwdriver.
Remove the bottom panel of the speaker.

Unscrew the six 6mm screws with a Phillips head #1 screwdriver.

Remove the bottom panel of the speaker.

Step 3

Unplug the battery by gently pinching the plastic end connected to the smaller board and pull away.
Remove the battery.

Unplug the battery by gently pinching the plastic end connected to the smaller board and pull away.

Remove the battery.

Step 4

              Speaker

To remove the speaker grill, first push down slightly on the 2 plastic hook tabs to release them, then push the middle plastic screw tab out.

To remove the speaker grill, first push down slightly on the 2 plastic hook tabs to release them, then push the middle plastic screw tab out.

Step 5

Remove the eight 0.5mm Phillips #1 screws from the speaker panel.

Remove the eight 0.5mm Phillips #1 screws from the speaker panel.

Step 6

Using the plastic opening tool, flip open the speaker panel.

Using the plastic opening tool, flip open the speaker panel.

Step 7

Unplug the 6-pin speaker connector and 2-pin microphone connector from the motherboard by squeezing the sides of the plastic ends.

Unplug the 6-pin speaker connector and 2-pin microphone connector from the motherboard by squeezing the sides of the plastic ends.

Step 8

              Bluetooth

Unplug the cord connected to the motherboard by squeezing the plastic sides.

Unplug the cord connected to the motherboard by squeezing the plastic sides.

Step 9

Gently tug on the plastic ribbon connected to the bottom side of the speaker to unplug it.

Gently tug on the plastic ribbon connected to the bottom side of the speaker to unplug it.

Step 10

Remove the motherboard.

Remove the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors

                    Jeffrey Yalung

Member since: 09/28/2016

436 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Eastern Washington University, Team 2-6, Mathisen Fall 2016                        

                                                  Member of Eastern Washington University, Team 2-6, Mathisen Fall 2016 



                    EWU-MATHISEN-F16S2G6                     


                                            4 Members                     


                                            5 Guides authored

LUIS CARLOS MEJIA DIAZ - Aug 10, 2017

Muy bueno! Gracias Jeffrey!.

Introduction#

What you need#

Team#

Introduction

What you need

Team