Difficulty

Moderate

Steps

11

Time Required

Suggest a time??

Sections

2

  • Sony Radio Model CFD S05 Prerequisite steps Replacement
  • 5 steps
  • Audio in Jack
  • 6 steps

Flags

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSony Radio CFD-S05

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Sony Radio Model CFD S05 Prerequisite steps Replacement
  • Unscrew the screws on the top of the radio.

Unscrew the screws on the top of the radio.

1024

Step 2

  • Open the CD and cassette doors and remove the screws in the compartments.
  • To open the CD door push on the bottom left corner of the CD door. To open the cassette door push the button that is to the left of the pause button.

Open the CD and cassette doors and remove the screws in the compartments.

To open the CD door push on the bottom left corner of the CD door. To open the cassette door push the button that is to the left of the pause button.

Step 3

  • Flip the radio upside down and remove the battery cover. Unscrew the one screw below the batteries.

Flip the radio upside down and remove the battery cover. Unscrew the one screw below the batteries.

Step 4

  • Remove the top of the radio enough to access the wires for removal.
  • Do not forcefully remove the whole top piece of the radio! There will be wires connected to the top cover and circuit board.

Remove the top of the radio enough to access the wires for removal.

Do not forcefully remove the whole top piece of the radio! There will be wires connected to the top cover and circuit board.

Step 5

  • Remove all of the wires that are connected to both the circuit board and the underside of the top of the radio by pulling them where they are connected
  • This should include three sets of red and white wires, one set of white wires, one set of black wires, and two ribbon wires. Some cannot be disconnected from the top piece of the radio. Disconnect these plugs from the circuit board.

Remove all of the wires that are connected to both the circuit board and the underside of the top of the radio by pulling them where they are connected

This should include three sets of red and white wires, one set of white wires, one set of black wires, and two ribbon wires. Some cannot be disconnected from the top piece of the radio. Disconnect these plugs from the circuit board.

Step 6

              Audio in Jack
  • Unscrew the screws on the top right and top left of the back side of the buttons of the radio.

Unscrew the screws on the top right and top left of the back side of the buttons of the radio.

Step 7

  • Pull out the buttons of the radio from the inside.

Pull out the buttons of the radio from the inside.

Step 8

  • Pull out the audio in jack which is located on the right side of the radio directly below where the buttons are.

Pull out the audio in jack which is located on the right side of the radio directly below where the buttons are.

Step 9

  • Remove the audio in jack from the circuit board by pulling on the wires where they are connected to the board.

Remove the audio in jack from the circuit board by pulling on the wires where they are connected to the board.

Step 10

  • Connect the new audio in jack wires to the circuit board where the old one used to be.

Connect the new audio in jack wires to the circuit board where the old one used to be.

Step 11

  • Insert the new audio in jack into the hole on the back side of the front face of the radio.

Insert the new audio in jack into the hole on the back side of the front face of the radio.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 2 other contributors 


                    Ian Nussman

Member since: 10/25/2013

959 Reputation

                                      6 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 2-5, Gulbrandsen Fall 2013                        

                                                  Member of UMass Dartmouth, Team 2-5, Gulbrandsen Fall 2013 



                    UMASSD-GULBRANDSEN-F13S2G5                     


                                            2 Members                     


                                            6 Guides authored

louis roy - Apr 13, 2018

Reply

En français cela serrais mieux