Difficulty
Easy
Steps
4
Time Required
4 minutes
Sections
1
- Drive Belt
- 4 steps
Flags
0
BackSony PS-LX300USB
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Drive Belt
- Lift the rubber mat, and put it to the side. It should be easy to remove, because it simply rests on a metal platter without anything securing it down.
Lift the rubber mat, and put it to the side. It should be easy to remove, because it simply rests on a metal platter without anything securing it down.
1024
Step 2
- Turn the platter so that the motor pulley can be seen through one of the two outer holes in the platter.
- If the drive belt is hooked around the motor pulley, unhook it.
- When reassembling to device, don’t forget to hook the new drive belt to the motor pulley.
Turn the platter so that the motor pulley can be seen through one of the two outer holes in the platter.
If the drive belt is hooked around the motor pulley, unhook it.
When reassembling to device, don’t forget to hook the new drive belt to the motor pulley.
Step 3
- Grasping the platter by its two inner holes, lift it upwards.
- Removing the platter may take a small amount of force. If the pulley is unhooked and the tone arm is safely to the side, don’t fear using a small amount of force in lifting the platter.
- If you haven’t yet unhooked the drive belt, the motor pulley and the belt could sustain damage.
Grasping the platter by its two inner holes, lift it upwards.
Removing the platter may take a small amount of force. If the pulley is unhooked and the tone arm is safely to the side, don’t fear using a small amount of force in lifting the platter.
If you haven’t yet unhooked the drive belt, the motor pulley and the belt could sustain damage.
Step 4
- Peel the drive belt from the inner ridge of the metal platter and put it to the side.
- Sometimes, the drive belt can fall off the platter during deconstruction. If this is the case, simply take it out of the device wherever it is.
Peel the drive belt from the inner ridge of the metal platter and put it to the side.
Sometimes, the drive belt can fall off the platter during deconstruction. If this is the case, simply take it out of the device wherever it is.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
14 other people completed this guide.
Author
with 1 other contributor
Michelle Jakab
Member since: 09/27/2017
498 Reputation
1 Guide authored
Badges:
10
+7 more badges
Team
Cal Poly, Team S8-G3, Banghart Fall 2017
Member of Cal Poly, Team S8-G3, Banghart Fall 2017
CPSU-BANGHART-F17S8G3
5 Members
5 Guides authored
Jeanine Haven - Jan 6, 2018
Reply
Thank you for posting!
Thank you for posting this! My belt slipped and I could not figure this out thanks to you I saw how simple a process the repair. Many times thank you
Eric Doner - Jan 10, 2021
Reply
Thank you for this post. I freaked out when belt became detached. I had moved turntable several times to resolve a connection issue and OOPS! Very concise instructions with clear pictures. Awesome!!