Difficulty
Moderate
Steps
6
Time Required
30 minutes
Sections
2
- Rear Case
- 4 steps
- Indicator Light Bar
- 2 steps
Flags
0
BackSony PlayStation 3D Display
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Case
- Remove the base by pushing in the button and sliding out the unit.
Remove the base by pushing in the button and sliding out the unit.
1024
Step 2
- Remove USB port cover from back plate with a metal spudger.
- This will prevent the cover from falling under the back plate once it is removed.
Remove USB port cover from back plate with a metal spudger.
This will prevent the cover from falling under the back plate once it is removed.
Step 3
- With the Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate.
- With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.
- These screws have different threads and need to be kept separate.
With the Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate.
With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.
These screws have different threads and need to be kept separate.
Step 4
- Remove back plate with a plastic opening tool by slowing prying around the entire plate.
- Be gentle to avoid breaking the plastic clips which hold the plate.
- Once separated the plate easily lifts off.
Remove back plate with a plastic opening tool by slowing prying around the entire plate.
Be gentle to avoid breaking the plastic clips which hold the plate.
Once separated the plate easily lifts off.
Step 5
Indicator Light Bar
- With the Phillips #02 screwdriver, remove the two 5mm length x 5mm head screws located on the left and right side of the light bar board.
With the Phillips #02 screwdriver, remove the two 5mm length x 5mm head screws located on the left and right side of the light bar board.
Step 6
- Remove the light bar by depressing the tab on the white data connector.
Remove the light bar by depressing the tab on the white data connector.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Kyle Franck
Member since: 10/01/2015
233 Reputation
1 Guide authored
Badges:
12
+9 more badges
Team
Cal Poly, Team 12-16, Maness Fall 2015
Member of Cal Poly, Team 12-16, Maness Fall 2015
CPSU-MANESS-F15S12G16
4 Members
8 Guides authored