Difficulty

Moderate

Steps

6

Time Required

                          20 minutes            

Sections

2

  • Rear Case
  • 4 steps
  • Control Buttons
  • 2 steps

Flags

0

  • BackSony PlayStation 3D Display

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Case               
  • Remove the base by pushing in the button and sliding out the unit.

Remove the base by pushing in the button and sliding out the unit.

1024

Step 2

  • Remove USB port cover from back plate with a metal spudger.
  • This will prevent the cover from falling under the back plate once it is removed.

Remove USB port cover from back plate with a metal spudger.

This will prevent the cover from falling under the back plate once it is removed.

Step 3

  • With the Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate.
  • With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.
  • These screws have different threads and need to be kept separate.

With the Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate.

With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.

These screws have different threads and need to be kept separate.

Step 4

  • Remove back plate with a plastic opening tool by slowing prying around the entire plate.
  • Be gentle to avoid breaking the plastic clips which hold the plate.
  • Once separated the plate easily lifts off.

Remove back plate with a plastic opening tool by slowing prying around the entire plate.

Be gentle to avoid breaking the plastic clips which hold the plate.

Once separated the plate easily lifts off.

Step 5

              Control Buttons               
  • With the Phillips #01 screwdriver, remove the two 5 mm length x 7 mm head screws from the top and bottom of the control button bar.

With the Phillips #01 screwdriver, remove the two 5 mm length x 7 mm head screws from the top and bottom of the control button bar.

Step 6

  • Detach the control button bar by depressing the small white tab that connects the bar to its wires.

Detach the control button bar by depressing the small white tab that connects the bar to its wires.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    Tia McNaughton                     

Member since: 10/01/2015

379 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Cal Poly, Team 12-16, Maness Fall 2015                        

                                                  Member of Cal Poly, Team 12-16, Maness Fall 2015 



                    CPSU-MANESS-F15S12G16                     


                                            4 Members                     


                                            8 Guides authored