Difficulty
Easy
Steps
5
Time Required
10 - 15 minutes
Sections
1
- E-Mount
- 5 steps
Flags
0
BackSony NEX-5T
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
E-Mount
- Hold the camera with one hand and the lens in another.
- With the hand holding the camera, simultaneously push down on the lens release button while twisting the lens counterclockwise then pull to remove the lens.
Hold the camera with one hand and the lens in another.
With the hand holding the camera, simultaneously push down on the lens release button while twisting the lens counterclockwise then pull to remove the lens.
1024
Step 2
- You may need to apply adequate force to remove these screws and be careful not to strip them as they are relatively weak.
- Using a PH0 Philip’s screwdriver, unscrew and remove the four 1.2mm Philip’s screws on the front of the E-mount.
- These screws are very small so make sure you do not misplace them.
- If a screw is stripped, you will need to refer to the ifixit stripped screw removal guide
You may need to apply adequate force to remove these screws and be careful not to strip them as they are relatively weak.
Using a PH0 Philip’s screwdriver, unscrew and remove the four 1.2mm Philip’s screws on the front of the E-mount.
These screws are very small so make sure you do not misplace them.
If a screw is stripped, you will need to refer to the ifixit stripped screw removal guide
Step 3
- Using your fingers, pull out and remove the top silver plate exposing a black spacer ring underneath.
- Repeat the previous step for the black spacer plate exposing the second silver spacer ring.
- Using your fingers or tweezers, pull out the second silver spacer ring.
- Note the positioning and order of each of the rings for reassembly.
Using your fingers, pull out and remove the top silver plate exposing a black spacer ring underneath.
Repeat the previous step for the black spacer plate exposing the second silver spacer ring.
Using your fingers or tweezers, pull out the second silver spacer ring.
Note the positioning and order of each of the rings for reassembly.
Step 4
- Using a PH0 Philip’s screwdriver, unscrew and remove the two 1.2mm Philip’s screws located on opposite sides of the lens mount.
- Using your fingers, pull off the lens housing.
Using a PH0 Philip’s screwdriver, unscrew and remove the two 1.2mm Philip’s screws located on opposite sides of the lens mount.
Using your fingers, pull off the lens housing.
Step 5
- Using tweazers, remove the lens release button.
- Because the small spring underneath is only held down by the button, removing the button will cause the spring to be loose. To avoid losing it, you may want to remove it as well.
Using tweazers, remove the lens release button.
Because the small spring underneath is only held down by the button, removing the button will cause the spring to be loose. To avoid losing it, you may want to remove it as well.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Chris Meseha
Member since: 03/02/2017
101 Reputation
1 Guide authored
Badges:
2
Team
USF Tampa, Team S13-G2, Cagle Spring 2017
Member of USF Tampa, Team S13-G2, Cagle Spring 2017
USFT-CAGLE-S17S13G2
3 Members
12 Guides authored