Difficulty
Moderate
Steps
9
Time Required
10 - 15 minutes
Sections
2
- Front Case
- 3 steps
- Rear Case
- 6 steps
Flags
0
BackSony NEX-5R
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Case
- Open the battery pack door by moving the slider to “OPEN”.
- Remove the 3.25 mm silver screw inside the battery pack with a Phillips screwdriver.
Open the battery pack door by moving the slider to “OPEN”.
Remove the 3.25 mm silver screw inside the battery pack with a Phillips screwdriver.
1024
Step 2
- Remove the 3.25 mm exterior screw with a Phillips screwdriver.
Remove the 3.25 mm exterior screw with a Phillips screwdriver.
Step 3
- Use the spudger to raise the corner of the case from the camera.
- One component of the front case should now be separate from the camera.
Use the spudger to raise the corner of the case from the camera.
One component of the front case should now be separate from the camera.
Step 4
Rear Case
- Remove the three (3.5 mm) screws from the bottom of the camera with the Phillips screwdriver.
Remove the three (3.5 mm) screws from the bottom of the camera with the Phillips screwdriver.
Step 5
- Open the HDMI port, and remove the the two (3.5 mm) Phillips screws exposed on that side.
Open the HDMI port, and remove the the two (3.5 mm) Phillips screws exposed on that side.
Step 6
- Remove the two 4mm screws from the interior of the battery pack, and one 3.5mm screw from beside it.
Remove the two 4mm screws from the interior of the battery pack, and one 3.5mm screw from beside it.
Step 7
- Looking at the bottom of the camera, use the spudger to lift the rear case away from the camera body.
Looking at the bottom of the camera, use the spudger to lift the rear case away from the camera body.
Step 8
- Using the spudger again, carefully pry from the top of the camera to remove the back frame.
- The back frame is fragile, so use the spudger gently.
Using the spudger again, carefully pry from the top of the camera to remove the back frame.
The back frame is fragile, so use the spudger gently.
Step 9
- The back case should now be removed and look like this.
The back case should now be removed and look like this.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 6 other contributors
Emily Trujillo
Member since: 04/08/2014
1,114 Reputation
6 Guides authored
Badges:
15
+12 more badges
Team
Cal Poly, Team 8-9, Regan Spring 2014
Member of Cal Poly, Team 8-9, Regan Spring 2014
CPSU-REGAN-S14S8G9
4 Members
14 Guides authored