Difficulty
Easy
Steps
6
Time Required
5 minutes
Sections
1
- HDD
- 6 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackSony Handycam DCR-SR68
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
HDD
- Wash and dry your hands, then put on a properly grounded anti-static wrist strap, before handling internal electronic components. To ground the wrist strap, attach it to the metal chassis of a plugged-in three prong power supply, of a computer for example.
- Unfasten the hand strap.
- Remove the battery.
Wash and dry your hands, then put on a properly grounded anti-static wrist strap, before handling internal electronic components. To ground the wrist strap, attach it to the metal chassis of a plugged-in three prong power supply, of a computer for example.
Unfasten the hand strap.
Remove the battery.
1024
Step 2
- Place device on left side with front lens facing right.
- Using a JIS size #00 precision Phillips screwdriver, unscrew the left middle 3mm Phillips screw.
- Open the “DC IN” plastic tab (Second 3mm Phillips screw is revealed).
- Unscrew the second 3mm Phillips screw.
Place device on left side with front lens facing right.
Using a JIS size #00 precision Phillips screwdriver, unscrew the left middle 3mm Phillips screw.
Open the “DC IN” plastic tab (Second 3mm Phillips screw is revealed).
Unscrew the second 3mm Phillips screw.
Step 3
- Turn device over onto its top with the front lens facing right.
- Unscrew the top left and top right 3mm Philips screws.
- The right side case panel is now unfastened (the case panel facing up in the photo).
Turn device over onto its top with the front lens facing right.
Unscrew the top left and top right 3mm Philips screws.
The right side case panel is now unfastened (the case panel facing up in the photo).
Step 4
- Remove the right side case panel by pulling up.
- The Hard Drive (HDD) is now revealed.
Remove the right side case panel by pulling up.
The Hard Drive (HDD) is now revealed.
Step 5
- Using your fingers, lift the HDD from its right end, pivoting on its left end.
- The HDD ribbon wire is now exposed.
Using your fingers, lift the HDD from its right end, pivoting on its left end.
The HDD ribbon wire is now exposed.
Step 6
- While securely holding the HDD in your left hand, use the soft pad of your right hand fingers to gently pull the ribbon wire out of its socket, toward your right.
- The HDD is now free from the device.
- Replace HDD.
While securely holding the HDD in your left hand, use the soft pad of your right hand fingers to gently pull the ribbon wire out of its socket, toward your right.
The HDD is now free from the device.
Replace HDD.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Greg Thorburn
Member since: 01/06/2016
353 Reputation
1 Guide authored
Badges:
10
+7 more badges
Team
Eastern Washington University, Team 2-5, Andersen Winter 2016
Member of Eastern Washington University, Team 2-5, Andersen Winter 2016
EWU-ANDERSEN-W16S2G5
5 Members
12 Guides authored