Difficulty
Moderate
Steps
7
Time Required
Suggest a time??
Sections
1
- Hard Drive
- 7 steps
Flags
0
BackSony Handycam DCR-SR42
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Luckily, replacing the hard drive of the DCR-SR42 is a simple procedure that will take no more than 20 minutes. However, the user should be careful when disassembling the camera in order to avoid damaging the flex cable or any other internal components of the camera. The user should also ensure that the battery is disconnected from the camera at least an hour before disassembly is attempted, since capacitors inside the camera can remain charged with electricity some time after the battery is removed. It is necessary to allow capacitors to discharge to prevent injury to the user or damage to the camera.
For problems pertaining to the hard drive, please refer to the Sony Handycam DCR SR-42 Troubleshooting Guide
What you need
Step 1
Hard Drive
- Remove the battery, and use the Phillips #00 precision screwdriver to then remove the three 3mm Phillips #00 screws under the battery.
- Wait 1 hour after removing the battery before continuing to disassemble the camera.
Remove the battery, and use the Phillips #00 precision screwdriver to then remove the three 3mm Phillips #00 screws under the battery.
Wait 1 hour after removing the battery before continuing to disassemble the camera.
1024
Step 2
- Remove the three 3mm #00 Phillips screws on the bottom of the camera.
Remove the three 3mm #00 Phillips screws on the bottom of the camera.
Step 3
- Remove the three 3mm Phillips #00 screws on the side of the camera.
- Remove the 4mm Phillips #00 screw under the AV port cover.
Remove the three 3mm Phillips #00 screws on the side of the camera.
Remove the 4mm Phillips #00 screw under the AV port cover.
Step 4
- Gently pull the black plastic hard drive cover away from the body of the camera. This will expose the hard drive.
- Even with all the screws removed, this part will require some force to remove.
Gently pull the black plastic hard drive cover away from the body of the camera. This will expose the hard drive.
Even with all the screws removed, this part will require some force to remove.
Step 5
- Lift the hard drive out of the camera by grasping the grey rubber mounting brackets and pulling them upwards.
- The hard drive is attached to the flex cable. Remove the hard drive slowly to prevent the flex cable from being damaged.
Lift the hard drive out of the camera by grasping the grey rubber mounting brackets and pulling them upwards.
The hard drive is attached to the flex cable. Remove the hard drive slowly to prevent the flex cable from being damaged.
Step 6
- Remove the rubber mounting brackets by pulling them off the hard drive.
Remove the rubber mounting brackets by pulling them off the hard drive.
Step 7
- Carefully unplug the flex cable from the hard drive.
Carefully unplug the flex cable from the hard drive.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 3 other contributors
Dan Muller
Member since: 03/23/2015
951 Reputation
5 Guides authored
Badges:
12
+9 more badges
Team
Baylor, Team 7-13, Williams Spring 2015
Member of Baylor, Team 7-13, Williams Spring 2015
BU-WILLIAMS-S15S7G13
4 Members
10 Guides authored
JORGE - Sep 30, 2016
Reply
Gracias por el post. Muy buenas las explicaciones.
Una consulta.
Tengo filmadora SONY DRC-SR21 cuyo disco original es Toshiba MKL8034GAL.
Puedo usar un disco de 30GB para reemplazarlo ?
Intenté hacerlo pero al encender la filmadora, vuelve a apagarse.
El disco original es de 500mA y el de 30GB es de 400mA.
Gracias por la ayuda
Ger O’Neill - Apr 21, 2021
Reply
Hi, that’s a very comprehensive tutorial, well done!
I’m trying to find out if I can access video footage recorded onto a sony handycam ( DCR-SR75) The LCD screen stopped working and I can’t seem to operate the memory. I would appreciate any advise or suggestions as how to sort this problem thanks, Ger