Difficulty
Moderate
Steps
11
Time Required
5 - 10 minutes
Sections
7
- Back Phone Cover
- 1 step
- Battery
- 1 step
- Sim Card
- 1 step
- Back Dark Grey Case
- 3 steps
- Motherboard
- 3 steps
- Keypad
- 1 step
- Microphone
- 1 step
Flags
1
Missed a Step
Oops! This guide is currently missing some important steps.
BackSony Ericsson z300
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Phone Cover
- To remove the back cover, use your thumb to press down on the center of case and slide it off.
To remove the back cover, use your thumb to press down on the center of case and slide it off.
1024
Step 2
Battery
- Using a fingernail lift the battery out of the phone.
Using a fingernail lift the battery out of the phone.
Step 3
Sim Card
- Slide the sim card out with your thumb.
Slide the sim card out with your thumb.
Step 4
Back Dark Grey Case
- To remove the back case first remove the four screws shown with a T5 Torx screwdriver
To remove the back case first remove the four screws shown with a T5 Torx screwdriver
Step 5
- Using your fingernail lift up the side of the casing around the bottom of the phone to release all five of the clips.
Using your fingernail lift up the side of the casing around the bottom of the phone to release all five of the clips.
Step 6
- Lift up towards the bottom and slide the case off.
Lift up towards the bottom and slide the case off.
Step 7
Motherboard
- Use a plastic opening tool to lift up the brass colored panel.
Use a plastic opening tool to lift up the brass colored panel.
Step 8
- Flip up the yellow tab using a plastic opening tool to disconnect the motherboard from the phone body.
Flip up the yellow tab using a plastic opening tool to disconnect the motherboard from the phone body.
Step 9
- Work the plastic opening tool around the edges of the motherboard to release it from the clips.
Work the plastic opening tool around the edges of the motherboard to release it from the clips.
Step 10
Keypad
- Using a plastic opening tool lift up the keypad to remove it.
Using a plastic opening tool lift up the keypad to remove it.
Step 11
Microphone
- Use a plastic opening tool to lift the microphone out of its circular slot.
Use a plastic opening tool to lift the microphone out of its circular slot.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Alex Serventi
Member since: 10/07/2010
65 Reputation
13 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team 5-15, Maness Fall 2010
Member of Cal Poly, Team 5-15, Maness Fall 2010
CPSU-MANESS-F10S5G15
4 Members
26 Guides authored