Sony Ericsson Quickshare T630 Screen Replacement Repair Guide

Difficulty

Moderate

Steps

11

Time Required

                          5 - 10 minutes            

Sections

2

• Sony Ericsson QuickShare T630 Phone Enclosure
• 10 steps
• Sony Ericsson QuickShare T630 Screen
• 1 step

Flags

0

• BackSony Ericsson QuickShare T630

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Sony Ericsson QuickShare T630 Phone Enclosure               

• Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.

Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.

1024

Step 2

• Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.

Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.

Step 3

• Slide the battery upward to remove.

Slide the battery upward to remove.

Step 4

• Remove the rubber plug located near the camera by gently prying upward with your fingers.
• Gently lift the camera shield after removal of the rubber plug.

Remove the rubber plug located near the camera by gently prying upward with your fingers.

Gently lift the camera shield after removal of the rubber plug.

Step 5

• Pry the remaining panel to loosen its contact to the phone using a spudger.
• Slide the panel upward to remove it completely.
• These steps will require a slight appliance of force.

Pry the remaining panel to loosen its contact to the phone using a spudger.

Slide the panel upward to remove it completely.

These steps will require a slight appliance of force.

Step 6

• Slide the aerial upward to remove it.

Slide the aerial upward to remove it.

Step 7

• Remove the four screws located at each corner of the device.

Remove the four screws located at each corner of the device.

Step 8

• Gently lift and remove the front panel of the phone after removing the screws.

Gently lift and remove the front panel of the phone after removing the screws.

Step 9

• This step is NOT required for joystick maintenance or keypad maintenance and replacement! Continue on to step 10 if you are attempting to achieve either of these goals.
• Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.
• Gently pull the ribbon from the circuit.
• Remove the now disconnected screen.

This step is NOT required for joystick maintenance or keypad maintenance and replacement! Continue on to step 10 if you are attempting to achieve either of these goals.

Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.

Gently pull the ribbon from the circuit.

Remove the now disconnected screen.

Step 10

• Remove the keyboard by slowly pulling it away from the circuit board.
• There are no direct connections between the keyboard and phone.
• These are all of the parts covered in this disassembly that make up the Sony Ericsson QuickShare T630.

Remove the keyboard by slowly pulling it away from the circuit board.

There are no direct connections between the keyboard and phone.

These are all of the parts covered in this disassembly that make up the Sony Ericsson QuickShare T630.

Step 11

              Sony Ericsson QuickShare T630 Screen               

• To place a new screen, slide the green ribbon connector into the ribbon clamp that the defective screen was pulled from.

To place a new screen, slide the green ribbon connector into the ribbon clamp that the defective screen was pulled from.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 6 other contributors 

                    Jeremy                     

Member since: 10/16/2013

166 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       University of Maine, Team 1-1, Diaz Fall 2013                        

                                                  Member of University of Maine, Team 1-1, Diaz Fall 2013 



                    UMAINE-DIAZ-F13S1G1                     


                                            4 Members                     


                                            6 Guides authored                     

roger hiley - Oct 3, 2015

Reply

Worked well until the screen replacemet - ribbon cable would not go into clamp - phone plus new screen straight in the bin - a little gutted - but hey it was an old but loved phone.