Sony Ericsson Quickshare T630 Keypad Maintenance And Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Sony Ericsson QuickShare T630 Phone Enclosure
10 steps
Sony Ericsson QuickShare T630 Keypad Maintenance and Replacement
2 steps

Flags

BackSony Ericsson QuickShare T630
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Sony Ericsson QuickShare T630 Phone Enclosure

Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.

Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.

1024

Step 2

Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.

Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.

Step 3

Slide the battery upward to remove.

Slide the battery upward to remove.

Step 4

Remove the rubber plug located near the camera by gently prying upward with your fingers.
Gently lift the camera shield after removal of the rubber plug.

Remove the rubber plug located near the camera by gently prying upward with your fingers.

Gently lift the camera shield after removal of the rubber plug.

Step 5

Pry the remaining panel to loosen its contact to the phone using a spudger.
Slide the panel upward to remove it completely.
These steps will require a slight appliance of force.

Pry the remaining panel to loosen its contact to the phone using a spudger.

Slide the panel upward to remove it completely.

These steps will require a slight appliance of force.

Step 6

Slide the aerial upward to remove it.

Slide the aerial upward to remove it.

Step 7

Remove the four screws located at each corner of the device.

Remove the four screws located at each corner of the device.

Step 8

Gently lift and remove the front panel of the phone after removing the screws.

Gently lift and remove the front panel of the phone after removing the screws.

Step 9

This step is NOT required for joystick maintenance or keypad maintenance and replacement! Continue on to step 10 if you are attempting to achieve either of these goals.
Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.
Gently pull the ribbon from the circuit.
Remove the now disconnected screen.

This step is NOT required for joystick maintenance or keypad maintenance and replacement! Continue on to step 10 if you are attempting to achieve either of these goals.

Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.

Gently pull the ribbon from the circuit.

Remove the now disconnected screen.

Step 10

Remove the keyboard by slowly pulling it away from the circuit board.
There are no direct connections between the keyboard and phone.
These are all of the parts covered in this disassembly that make up the Sony Ericsson QuickShare T630.

Remove the keyboard by slowly pulling it away from the circuit board.

There are no direct connections between the keyboard and phone.

These are all of the parts covered in this disassembly that make up the Sony Ericsson QuickShare T630.

Step 11

              Sony Ericsson QuickShare T630 Keypad Maintenance and Replacement

After wetting the cotton swab with the rubbing alcohol, rub the keypad with the swab until the buttons are clean.
Dry out the keypad by placing it on a flat surface before reassembling the device.

After wetting the cotton swab with the rubbing alcohol, rub the keypad with the swab until the buttons are clean.

Dry out the keypad by placing it on a flat surface before reassembling the device.

Step 12

If the keypad is beyond maintenance, replacement is simple.
Purchase a new keypad and put it in place of the old keypad.
Purchase replacement keypads here

If the keypad is beyond maintenance, replacement is simple.

Purchase a new keypad and put it in place of the old keypad.

Purchase replacement keypads here

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Kelsey

Member since: 10/28/2013

107 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       University of Maine, Team 1-1, Diaz Fall 2013                        

                                                  Member of University of Maine, Team 1-1, Diaz Fall 2013 



                    UMAINE-DIAZ-F13S1G1                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team