Difficulty

Moderate

Steps

8

Time Required

                          15 minutes            

Sections

1

  • Motherboard
  • 8 steps

Flags

0

  • BackSony Cyber-shot DSC-WX350

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Motherboard               
  • Remove 6 Phillips 4mm screws from the bottom and sides of the device.
  • Remove the 1 Phillips 4mm screw from under the battery cover.

Remove 6 Phillips 4mm screws from the bottom and sides of the device.

Remove the 1 Phillips 4mm screw from under the battery cover.

1024

Step 2

  • Insert the plastic opening tool between the back cover and the bottom plate. Gently pry the cover off.

Insert the plastic opening tool between the back cover and the bottom plate. Gently pry the cover off.

Step 3

  • Use your fingers to slide out the controller wheel board.

Use your fingers to slide out the controller wheel board.

Step 4

  • On the left side of the camera, pull the LCD off the back plate.
  • There will be a ZIF connector by the control wheel, release the connector and remove the LCD.

On the left side of the camera, pull the LCD off the back plate.

There will be a ZIF connector by the control wheel, release the connector and remove the LCD.

Step 5

  • Once the LCD is off use the J00 screwdriver to take out the two 4mm silver screws. Once the screws are taken out pull off the piece with your fingers.

Once the LCD is off use the J00 screwdriver to take out the two 4mm silver screws. Once the screws are taken out pull off the piece with your fingers.

Step 6

  • Remove the three ZIFs connected to the motherboard. The top is found under a piece of tape.

Remove the three ZIFs connected to the motherboard. The top is found under a piece of tape.

Step 7

  • Remove the lens assembly and motherboard from the front of the case.
  • The lens assembly should separate when removing the front.

Remove the lens assembly and motherboard from the front of the case.

The lens assembly should separate when removing the front.

Step 8

  • On the backside of the motherboard, a silver clip is holding the motherboard to the plastic shell. Insert the plastic opening tool under the clip and pry gently until it releases.

On the backside of the motherboard, a silver clip is holding the motherboard to the plastic shell. Insert the plastic opening tool under the clip and pry gently until it releases.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Ryan Speitel                     

Member since: 05/22/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       IUPUI, Team S1-G1, Wilson Summer 2017                        

                                                  Member of IUPUI, Team S1-G1, Wilson Summer 2017 



                    IUPUI-WILSON-SU17S1G1                     


                                            4 Members                     


                                            3 Guides authored