Difficulty
Moderate
Steps
10
Time Required
15 minutes
Sections
4
- Battery
- 3 steps
- Front and Back Panel
- 3 steps
- Button Board
- 2 steps
- Flash Board
- 2 steps
Flags
0
BackSony Cyber-Shot DSC-W830
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Slide the lock at the bottom of the camera to “Open”.
- The door to the battery pack is spring loaded.
Slide the lock at the bottom of the camera to “Open”.
The door to the battery pack is spring loaded.
1024
Step 2
- Slide the blue clip up and away from the battery.
Slide the blue clip up and away from the battery.
Step 3
- Remove the battery.
Remove the battery.
Step 4
Front and Back Panel
- Remove the six 3.5mm Phillips #000 screws.
- Rotate the lock away from the camera.
Remove the six 3.5mm Phillips #000 screws.
Rotate the lock away from the camera.
Step 5
- Pry the device open with the plastic opening tool.
- There are two clips that help prevent the front panel from separating.
Pry the device open with the plastic opening tool.
There are two clips that help prevent the front panel from separating.
Step 6
- Remove the two plastic spacers between the front and the back panels.
- The spacers may fall out when removing the panels.
- Carefully remove the back panel.
Remove the two plastic spacers between the front and the back panels.
The spacers may fall out when removing the panels.
Carefully remove the back panel.
Step 7
Button Board
- Gently release the button board from the clips.
- Be careful when lifting the button board; the ribbon cable will still be attached.
Gently release the button board from the clips.
Be careful when lifting the button board; the ribbon cable will still be attached.
Step 8
- Disconnect the no-fuss ribbon cable by gently pulling it out of the button board.
Disconnect the no-fuss ribbon cable by gently pulling it out of the button board.
Step 9
Flash Board
- Gently pry the flash board up from its clips.
Gently pry the flash board up from its clips.
Step 10
- Gently pull out the no-fuss ribbon cable from the flash board.
Gently pull out the no-fuss ribbon cable from the flash board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Tong Tang
Member since: 09/15/2016
536 Reputation
4 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 17-1, Blackwell Fall 2016
Member of USF Tampa, Team 17-1, Blackwell Fall 2016
USFT-BLACKWELL-F16S17G1
4 Members
6 Guides authored
