Difficulty
Easy
Steps
8
Time Required
15 minutes
Sections
3
- Outer Case
- 5 steps
- LCD Control Board
- 1 step
- LCD Screen
- 2 steps
Flags
0
BackSony Cyber-shot DSC-W730
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Removing the Case
- Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.
Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.
1024
Step 2
- Take off the front part of the case with a plastic opening tool.
Take off the front part of the case with a plastic opening tool.
Step 3
- Pull off the two silver side pieces on the left and right sides.
Pull off the two silver side pieces on the left and right sides.
Step 4
- Remove the main back piece. It should easily lift off.
Remove the main back piece. It should easily lift off.
Step 5
- Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.
Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.
Step 6
LCD Control Board
- Flip over the control board then use tweezers to pull out the ribbon connecting the circuit board to the motherboard.
Flip over the control board then use tweezers to pull out the ribbon connecting the circuit board to the motherboard.
Step 7
LCD Screen
- Use tweezers to remove the ribbon that is connected from the LCD screen to the camera by pulling the part that is folded under, out.
Use tweezers to remove the ribbon that is connected from the LCD screen to the camera by pulling the part that is folded under, out.
Step 8
- Slide the right side of the LCD screen clockwise, which will push it off the camera. The rest of the screen should come off with it with ease.
Slide the right side of the LCD screen clockwise, which will push it off the camera. The rest of the screen should come off with it with ease.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Jeremy Petchonka
Member since: 01/20/2015
279 Reputation
2 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 9-4, Blackwell Winter 2015
Member of USF Tampa, Team 9-4, Blackwell Winter 2015
USFT-BLACKWELL-W15S9G4
3 Members
12 Guides authored
joao - Feb 13, 2016
Reply
Excellent tutorial. It helped me a lot. I ve just replaced my LCD with success.
Thank you
Robin_o - Oct 26, 2018
Reply
I can record with the camera but I can’t see the image while taking photos. Any suggestions?