Difficulty

Easy

Steps

6

Time Required

                          10 minutes

Sections

2

  • Outer Case
  • 5 steps
  • Flash Capacitor
  • 1 step

Flags

0

  • BackSony Cyber-shot DSC-W730

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Removing the Case
  • Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.

Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.

1024

Step 2

  • Take off the front part of the case with a plastic opening tool.

Take off the front part of the case with a plastic opening tool.

Step 3

  • Pull off the two silver side pieces on the left and right sides.

Pull off the two silver side pieces on the left and right sides.

Step 4

  • Remove the main back piece. It should easily lift off.

Remove the main back piece. It should easily lift off.

Step 5

  • Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.

Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.

Step 6

              Flash Capacitor
  • Lift the capacitor out and gently pull it away from the control board to unplug the ribbon attached to the side of the circuit board. Be careful not to bend the ribbon.

Lift the capacitor out and gently pull it away from the control board to unplug the ribbon attached to the side of the circuit board. Be careful not to bend the ribbon.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Douglas Howe

Member since: 01/08/2015

510 Reputation

                                      4 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges

Team

                       USF Tampa, Team 9-4, Blackwell Winter 2015                        

                                                  Member of USF Tampa, Team 9-4, Blackwell Winter 2015 



                    USFT-BLACKWELL-W15S9G4                     


                                            3 Members                     


                                            12 Guides authored