Difficulty
Moderate
Steps
5
Time Required
Suggest a time??
Sections
1
- Door
- 5 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackSony Cyber-shot DSC-W730 DSC-W830
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Determining your Problem
- make sure your door slider tab is in good shape. If the tab is damaged you will need a door replacement.
- make sure your tab notches are in good shape. If there is a problem with the notches then you will need to replace the front housing cover of the unit.
- If your door closes but looks like the unit in the 3rd picture then your door is either bent and damaged or the unit may not be assembled properly.
make sure your door slider tab is in good shape. If the tab is damaged you will need a door replacement.
make sure your tab notches are in good shape. If there is a problem with the notches then you will need to replace the front housing cover of the unit.
If your door closes but looks like the unit in the 3rd picture then your door is either bent and damaged or the unit may not be assembled properly.
1024
Step 2
Removing Rear Housing Case
- Remove 6 external screws from the casing. They are all the same size. I recommend using Phillips screwdriver size PH000
- Remove the rear casing. You may need a spudger to release the tab. The tab is a depression style tab
Remove 6 external screws from the casing. They are all the same size. I recommend using Phillips screwdriver size PH000
Remove the rear casing. You may need a spudger to release the tab. The tab is a depression style tab
Step 3
- remove side panels
remove side panels
Step 4
- Remove side panels and then remove front cover
Remove side panels and then remove front cover
Step 5
- Remove door rod
- Remove door assembly and replace with new door. Reverse process to assemble unit
- There is a little hole shown in the picture where the wire spring goes into.. make sure the wire spring is inserted into that hole or your door will not function.
Remove door rod
Remove door assembly and replace with new door. Reverse process to assemble unit
There is a little hole shown in the picture where the wire spring goes into.. make sure the wire spring is inserted into that hole or your door will not function.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Sales Cameraparts4you
Member since: 07/01/2016
3,042 Reputation
20 Guides authored
Badges:
17
+14 more badges